Ray-Ban Meta Smart Glasses Wayfarer Nose Pad -1mm
These are simple nose pads I made for the Ray-Ban Meta Wayfarer Smart Glasses.
They raise the glasses up by approximately 1mm to better center my prescription lens to my eyes.
If they're too thick or thin for you, use the scaling tool, uncheck “Uniform Scale” box, and adjust the Y axis as needed.
Keep in mind that printing too thick will cause your glasses to not fit into the case. Don't force them in, the retaining clip will break.
Print in TPU 95 or softer for more comfort.
Left and riight sides are not symmetrical.
The right side piece has a cutout for the microphone.
Attach with double sided tape.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.