Shower Rod/Curtain Holder - 32mm
Copyright Claim
Shower Rod/Curtain Holder - 32mm
Boost
3
9
1
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
37 min
1 plate
Boost
3
9
1
0
21
17
Released
Description
Made a basic shower rod holder that doesn't have a backing - needed a very low profile option for my application. Fits a 32mm rod.
Recommend printing upside down, assuming your printer can handle overhangs well. Otherwise, just print with support and it will be fine.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
So far so good! The ones I printed are used to hold up a curtain rod with two side tape.
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld