Panda Touch Bezel Cover
Copyright Claim
Panda Touch Bezel Cover
Boost
32
47
34
Print Profile(2)
MultiColor - 0.2mm layer, 2 walls, 5% infill
Designer
43 min
1 plate
Blank - 0.2mm layer, 2 walls, 5% infill
Designer
35 min
1 plate
Open in Bambu Studio
Boost
32
47
34
2
107
86
Released
Description
Created a slide on bezel thats a nice snug fit so you dont have to worry about pulling it off when grabbing the screen off the dock, but dont have to be the hulk to attach it either. I've also preserved the open spot on the side where the USB plug is. Simple print, no supports or anything special needed.
There are two profile versions.
The first profile is a blank bezel you could print on some fancy patterned print bed to get a nice effect bezel (or use to add your own text).
The second profile is multicolor using the AMS to add “Bambu Lab” in the bottom open area.
Feel free to offer suggestions or perhaps text you'd like to see on them. Check out my other model too!
Comment & Rating (34)
All
Works Great!
The designer has replied
2
Reply
Awesome! Thanks
0
Reply
Print Profile
MultiColor - 0.2mm layer, 2 walls, 5% infill
top
The designer has replied
1
Reply
looks great, thanks!
0
Reply
Print Profile
MultiColor - 0.2mm layer, 2 walls, 5% infill
spitze
The designer has replied
1
Reply
looks great
0
Reply
Print Profile
Blank - 0.2mm layer, 2 walls, 5% infill
This bezel fits perfectly. It fits securely and snug around the panda touch screen.
The designer has replied
1
Reply
thanks for the review
0
Reply
Print Profile
Blank - 0.2mm layer, 2 walls, 5% infill
Perfekt
The designer has replied
0
Reply
Looks great, thanks!
0
Reply
Print Profile
MultiColor - 0.2mm layer, 2 walls, 5% infill
(Edited)
The designer has replied
2
Reply
that's a beauty
(Edited)1
Reply
Print Profile
Blank - 0.2mm layer, 2 walls, 5% infill
printed with PETG
0
Reply
Print Profile
Blank - 0.2mm layer, 2 walls, 5% infill
Covers The Logo Great! Recommend!
(Edited)
0
Reply
Print Profile
MultiColor - 0.2mm layer, 2 walls, 5% infill
Other Issues:Print quality was great. when trying to install though, the faceplate cracked and snapped due to being to small and too tight. maybe it was designed for an earlier model of the panda touch. It sucks because I was really looking forward to hiding the bigtreetech logo.
The designer has replied
0
Reply
I'll have to look in to it, maybe try scaling it up a little bit and see if that helps? Then report back how much you scaled it case there's a variance in later models?
0
Reply
Print Profile
MultiColor - 0.2mm layer, 2 walls, 5% infill
The designer has replied
1
Reply
thanks!
0
Reply
Thank you!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld