Xbox controller desk mount
Copyright Claim
Xbox controller desk mount
Boost
28
55
18
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
28
55
18
3
95
84
Released
Description
Excellent desk mount for xbox controller. I have implemented a modification to prevent the sync button being pressed by mistake. I recommend printing from profile with .20mm strong settings for better toughness.
Comment & Rating (18)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
With many walls grids are too rigid, easier to grab the controller along with the holder than to extract it from the holder
(Edited)
The designer has replied
0
Reply
Thanks for the feedback. Mine works well, try pushing up the upper part a bit before extracting controller.
0
Reply
Did you print from PETG or PLA? I used eSUN matte PLA
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
good
The designer has replied
0
Reply
Nice print!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
perfect
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
The designer has replied
0
Reply
Sick pad! And nice print!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
no issues :)
The designer has replied
1
Reply
Thanks :)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
works perfect without a sleeve on controller but if you have a sleeve it is extremely tight fitting.
The designer has replied
0
Reply
Thanks for the feedback!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Nice.....
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld