To compete in Let There Be Light Contest from MakerWorld, I designed this modern lamp. But I didn't simply want to design a light fixture. Instead, I wanted to make it a bit more functional this time. So, I decided to add ability to wirelessly charge your phone.

Also, as usual, I have uploaded RAW step files for anyone to be able to customize it based on their needs. (I hope more and more makers start sharing step files for easier modifications.)

Print Settings

• Use 0.10mm or less layer height profile for better look and quite less post processing.
• Main Body doesn't need supports as printer can bridge without any issues, but if you're having issues with bridging, then enable supports. Very small surface requires supports anyway.
• Diffuser parts must be printed in Spiral Vase mode with 3 bottom layers, 0 top layers and 0.45mm line width for all.

Filaments Used

• Diffuser Top & Bottom – IIIDMax Vanilla Cream PLA+
• Diffuser Frame and Charging Ring – Hatchbox Wood PLA
• Main Body – Bambu Lab Gold PLA Silk

Required Hardware

• Wireless Charging Module – https://amzn.to/3umrnfY
• 5V USB COB LED Strip Light – https://amzn.to/4849oZm
• 2 Pin Mini Rocker Switch – https://amzn.to/3SqWord
• 8 6x3 Magnets – https://amzn.to/481W6N8
• Minimum 15watt Wall Charger
• Soldering materials and wire

Post-Processing Steps

Remember, these are the steps that I took. You do not have to do this, but it will surely make the lamp look much better and additionally the time required will be quite less if you printed with 0.10mm or less layer height. Overall time for post-processing was little less than hour excluding the drying wait time.

• Lightly sanded main body at the seam and joints with 180 grit
• Fill the seam and joints with Bondo Spot Putty – https://amzn.to/4b6PmjH
• Lightly sanded seam and joints again to make it smooth with 180 grit
• Used filler primer on all bodies – https://amzn.to/3Oir1O2
• Lightly sanded all bodies with 320 grit for final time
• Finally sprayed all bodies with regular primer and metallic gold paint – https://amzn.to/481bl91
• All wood filament parts are lightly sanded with 320 grit and stained with Dark Walnut Wood Stain – https://amzn.to/3UyLMZI

Assembly and Circuit Connection Steps

• First glue middle connector 1st and 2nd half using pin for alignment.
• Insert 8 magnets in Base top & bottom parts.
• Cut off the USB plug from LED strip as we will be soldering those wires directly to the wireless charging module later on for power supply to LEDs.
• Glue on Middle Connector tube on base top.
• Glue bottom diffuser to one of the diffuser frames.
• Glue bottom diffuser with frame onto middle connector.
• Stick COB LED to the wire tube and finish soldering wires.
• Glue on support rods on wire tube. (See pictures for proper orientation)
• Fish power supply wire from wire tube and middle connector to the bottom of the lamp.
• Glue wire tube on middle connector now.
• Glue another diffuser frame onto top diffuser.
• Glue top diffuser onto support rods and bottom diffuser frame.
• Solder led strip wires onto USB-C module of the wireless charging module and solder rocker switch in between.
• Glue wireless charging module under base top at the recessed area.
• Close base top with base bottom.