Bathroom radiator tower holders
Copyright Claim
Bathroom radiator tower holders
Boost
55
88
8
Print Profile(3)
0.2mm layer, 4 walls, honeycomb infill
Designer
1.1 h
1 plate
0.2mm layer, 4 walls, triangel infill
Designer
57 min
1 plate
0.2mm layer, 4 walls, archimedes infill
Designer
55 min
1 plate
Open in Bambu Studio
Boost
55
88
8
1
148
64
Released
Description
The most important things comes to your mind while sitting on the toilet.
So, there you have some desing to put toiletpaper and other stuff on (toiletpaper holder and universal hook).
Set your slicer with 0 of top and low layers and 4 perimeters. Then choose infill style you like.
Comment & Rating (8)
All
Sitz nur lose auf der Heizung. Bei der geringsten Berührung fällt der Halter ab. Nicht zu gebrauchen.
The designer has replied
0
Reply
Sorry to hear that. I use those holders daily without any issues. Do you have the same bathroom radiator model? Mine has 18mm gap between tubes.
If your hook falls down and you want to have it sit in one place, use some two-sided adhesive tape.
0
Reply
Print Profile
0.2mm layer, 4 walls, honeycomb infill
Works as expected.
If am not careful and push them upwards they tend to fall out on the backside of the radiator. Not an issue with the design but with the user ;)
0
Reply
Print Profile
0.2mm layer, 4 walls, honeycomb infill
passen, optisch sehr schön (in weiß gedruckt passend zur Heizung)
0
Reply
Print Profile
0.2mm layer, 4 walls, triangel infill
0
Reply
Print Profile
0.2mm layer, 4 walls, honeycomb infill
0
Reply
Print Profile
0.2mm layer, 4 walls, triangel infill
0
Reply
Print Profile
0.2mm layer, 4 walls, honeycomb infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld