💊 Pistol Mag Pill Dispenser 💊

This magazine-shaped pill dispenser resembles a real pistol mag in both appearance and function.

Load the clip with up to 7 pills, providing enough for a week of one capsule per day use. The dispenser, featuring a 3D printed spring, can be assembled without screws or glue within seconds.

Ensure the pills have a diameter of approximately 7.5 mm to fit into the dispenser.

The spring is effective in PLA but can also be printed in PETG to prevent the wear issues associated with PLA over time.

How to assemble:

Place the pusher and the spring inside one of the mag halves, ensuring the spring is held down to prevent it from jumping out.

Slide the second half of the mag on top, locking it into the featured hooks. Hold both halves together with one hand.

Slide the bottom cap over the two halves from the front, securing everything together.

Now load the clip.

And shoot the pills out again.