Ball Joint and Mount for an Anker eufyCam 2C Pro Wireless Home Security Add-on Camera
Boost
4
0
2
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
Open in Bambu Studio
Boost
4
0
2
0
15
10
Released
Description
The teeth on the back of the ball joint are prone to break, this is a replacement if this were to happen.
Comment & Rating (2)
All
The ball joint works perfectly. Unfortunately I couldn't get the camera to screw into the mount though. Could be a quality issue on my side. Either way, thanks for this! Saved me some modeling time.
The designer has replied
0
Reply
Thank you so much! sorry I have not been on here for a while. Assuming printing the thread is the issue, I found the best way to get it to print accuratly is either at a lower layer height and/or slow the speed down for outer walls.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld