Lego Ship Stand
Copyright Claim
Lego Ship Stand
Boost
73
150
30
Print Profile(2)
0.2mm layer, 2 walls, 20% infill
Designer
47 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Boost
73
150
30
7
180
277
Released
Comment & Rating (30)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
works great
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
took a little wiggling, but it’s a nice snug fit on every ship I added it to!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I would say the print is fine just a size issue doesn't fit perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Accidentally printed it without supports which didn't yield a good under surface to the top part. Also was too snug fitting into the bottom of my ship's bricks so I'm worried it may damage them long term.
But it does work overall despite those two issues as a basic display stand.
0
Reply
how to get this to work for a A1 mini?
The designer has replied
0
Reply
Uploaded an A1 mini Profile, so you can print it from the app! I don't have an A1 mini, but I did slice it in Bambu Studio as if I was sending it out to the mini. It has supports, which should be fairly easy to remove once printed, but print at your own risk. Let me know how it comes out!
(Edited)0
Reply
Replying to @Irvin1251
thank u
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Die wände sind ziemlich dünn auf einer Seite, warum?
Ansonsten passt es gut
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
stud length is just a fraction of a mm off, causing a very slight miss. other than that it’s a great print.
0
Reply
overall a pretty good print. studs on top are just off on the long measurement missing by about .26 mm.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
thanks for this :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
fits but holes are a bit weird to place
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld