Yeti Can Cooler Inspired Koozie
Copyright Claim
Yeti Can Cooler Inspired Koozie
Boost
66
96
18
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.3 h
1 plate
Open in Bambu Studio
Boost
66
96
18
4
155
163
Released
Description
Yeti Rambler Can Cooler inspired koozie. With a low infill of around 10% it seems to work pretty much just as good as the Yeti version since the cooling relies on the air insulation (double wall). The top fits perfectly on the Yeti one as well in case you lost your top. Hope you like it. Enjoy!
Update 06.24.24: I updated the lid to be a little thicker and more secure
Comment & Rating (18)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed a couple of them in different colors, they do work great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good, easy print. The lid settings could be dialed in to be more secure as right now it barely holds. Then the bottom just needs some sort of air relief hole(s) as it's such a tight fit for 355ml cans that you can push them in or pull them out due to the built up air pressure or vacuum.
3
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fits can perfectly
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Trying to print in Pteg so they will last a little longer and the top lip of the screw top is too thing so ends up not great no matter what I try. May just print the tops in PLA. But fits cans well so still a very good print. Will update to 5 Stars if PLA prints nice...
0
Reply
Boosted
worked rather well still trying to perfect the print in pteg, so that it lasts longer...
0
Reply
printed well, only issue i had was the overhanging base is a little rough/stringy. maybe fuzzy skin will fix this, or printing straight down and not curving in at the bottom.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
the brim is a little weak. gets super thin and just brakes off. Apart from this prints great. I added fuzzy skin and they turned out great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Should state clearly that this is for 355ml cans and not 330ml other than that it needs a tweak on the print speed of the lid to prevent seperation at the top
0
Reply
Seems too tall for my can? Maybe I am missing something?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Glad you liked it!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld