Print Profile(1)
0.12mm layer, 3 walls, 15% infill
Designer
5.8 h
1 plate
Open in Bambu Studio
Boost
43
87
6
1
116
31
Released
Description
A stand for the AppleTV in the style of an iMac desktop. It was designed around my 4th Gen AppleTV but it should work on the latest as well.
The AppleTV module slides in from the bottom and once in there will be a ledge cutout on the front side of the enclosure for the AppleTV to sit on. There will be a little bit of wiggle room until the stand is slid into the slot and presses against the rear of the AppleTV which should lock it into place. The small amount of space at the back should help with heat as well.
The I/O should be on the bottom so that the cables can be managed and fed down and through the hole in the stand. Unfortunately as a result of the cables coming from the bottom the AppleTV logo is upside down :(
Enjoy.
Comment & Rating (6)
All
Print Profile
0.12mm layer, 3 walls, 15% infill
nice concept. alittle too loose fit for the latest AppleTv generation/model
would almost prefer the cable coming out from the top so that logo on device is right-side up and a better fit. overall I like it
1
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
use with supports, wonderful and fun design! would suggest right angle HDMI connection or installing cables before installing stand to main.
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
Other Issues:apple tv fits in it, but not with cords attached, so it's useless
1
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld