External Spool Holder and Guide_Remix Roller for 80mm

Remixed by

External Spool Holder and Guide_Remix Roller for 80mm

Remixed by
Boost
0
3
4

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 4 walls, 15% infill
0.2mm layer, 4 walls, 15% infill
Designer
1.1 h
1 plate
5.0(4)

Boost
0
3
4
2
13
13
Released

Description

hello?
I needed an external spool guide, so I printed the original Ultrajaxel's External Spool Holder and Guide.

But the parts on the roller part did not fit, so I processed it several times and was not satisfied.

 

so I referred to another one and made one.
The original filament was made of ABS, but I used PLA. I think it may have been designed with the shrinkage of ABS in mind, so it did not fit PLA.
The width is designed to be 80mm and there is a gap of 0.4mm from the bearing.

Comment & Rating (4)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 4 walls, 15% infill
thanks for making this fix
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Printed in OVV3D Tri-color Red Blue Green Silk PLA without any problems. Rollers fit without a fuss!
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Used these rollers and pins and all went together tightly but very well! Printed in PLA+
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Printed in Red Bambu PLA Basic. The rollers on the original model were too tight a fit and broke when attempting to assemble. This remix was much better with slacker tolerances. 👍
0
Reply
No more