Nordic Table Set by Makefy

Makefy

Household>Decor

This model is created by Make My Vase

Make Your Model

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0,4mm Nozzle VASE MODE 1mm Wall width

Designer

3.5 h

3 plates

4.7(18)

0.6mm nozzle VASE MODE

Designer

3.5 h

3 plates

4.5(6)

Open in Bambu Studio

Boost

145

252

284

182

Released

Description

Decorate your space with this stylish set consisting of a bowl, a vase and a tealight candle holder.
I strongly recommend using a LED candle.

This profile is optimized for printing with a 0.6mm nozzle and an extrusion width of 0,8mm.
If you don't have a 0.6mm nozzle - reach out and maybe we can work something out other nozzle sizes.

- Or use the attached raw files to test out yourself!

Click Here to see the matching set of small planters.

Happy Printing!

Comment & Rating (40)

@user_1896108163

Print Profile

0,4mm Nozzle VASE MODE 1mm Wall width

top😝👌🏿Thanks🙏🏿

The designer has replied

@Makefy

Looks great! :)

(Edited)

@user_1896108163

Replying to @Makefy :

🙏🏿🙏🏿🙈🙏🏿

@Rimpelstullchen

Print Profile

0.6mm nozzle VASE MODE

Printing failed from layer 100, but maybe it's the petg-basic. I'll probably try again.

The designer has replied

@Makefy

Haven’t tried this model with PETG myself but could possible be some warping issues in combination with the constant overhang. Can’t tell exactly from your photo but slowing down might help. Really hope you can figure it out :)

@Rimpelstullchen

Replying to @Makefy :

Yes I also think it was the speed, it just didn't connect the layer well enough. I will probably also reduce the cooling a little.

@user_2090125546

👍🏼👍🏼

@malolepszy.mm

Print Profile

0,4mm Nozzle VASE MODE 1mm Wall width

awesome

@DLMusial

Print Profile

0,4mm Nozzle VASE MODE 1mm Wall width

very cool

@olemyk

Print Profile

0,4mm Nozzle VASE MODE 1mm Wall width

printes with Spectrum fillament

@KyGinNE3d

They turned out amazing. Did the three pieces from this set as well as the small planter/vace. Did this in kingroon pla black.

@makerlab_it

Print Profile

0,4mm Nozzle VASE MODE 1mm Wall width

Strength Issue

The designer has replied

@Makefy

Hi 😊Could you provide a picture to help me understand the problem?

@makerlab_it

Replying to @Makefy :

Hi ^^, the design is fantastic but I think it's a printing profile problem, I tried to print (PLA) twice starting from the smallest one, the first time I detached the piece from the plate and the bottom remained attached to the plate itself. In the second case I waited for it to cool, and it only came off on one side. I think the bottom is too thin.

@Makefy

Replying to @makerlab_it :

Thank you :) Could you try to put the printer in silent mode to slow it down a bit - and then make sure to let the print cool down completely before twisting the plate to release it? If you have no luck with this I can make a version with a thicker bottom :)