xtouch slim case
Copyright Claim
xtouch slim case
Boost
42
61
43
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
57 min
1 plate
0.2mm layer, 4 walls, 15% infill
1 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.2 h
1 plate
Boost
42
61
43
1
213
153
Released
Description
xtouch slim case. Uses 10x3mm magnets to allow easy mounting and removal
v2 of the base has a cutout for sd card access
Comment & Rating (43)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed without any issues.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super simple and quick, and the fit is perfect - the magnets didn’t even need glue. I am so excited at how well this looks and works!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great design! fits very neatly beside the original screen, looks almost factory. A1
1
Reply
Printed clean, like the lines.
0
Reply
Are there different sized ESP32-Display boards? Mine doesnt fit. Its only a little bit in height and width but the corner holes dont fit as well. Wouldnt move down enough for the USB-C/SD card to be on the right level.
The designer has replied
1
Reply
Thats the display i'm using.
0
Reply
Maybe some are different?? I only have one board so I only know about those dimensions. sorry!
0
Reply
I ordered a second one from Amazon. The difference is the usb port (c vs micro). The micro one fits!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I loved this because it don’t need screws and use magnete. it’snperfect sturdy and beautiful tu see. nice job !
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice Model, looks perfect. I just dont know how to put on the thing around the screen. Do I have to remove the current one first?
(Edited)The designer has replied
0
Reply
you unclip the LCD, the opposite of how you installed it, then slip the holder piece over the wire and then reinstall.
(Edited)1
Reply
Replying to @geoff.pedder
ah ok thank you!
(Edited)1
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Passt genau und ist ohne Probleme zu benutzen. Die Halterung samt Gehäuse erfüllt voll Ihren Zweck und passt auch noch gut zum Erscheinungsbild.
The designer has replied
0
Reply
danke, ich freue mich, dass es dir gefällt
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
had to scale it up a little too for the screen I got but worked perfectly otherwise.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Related Models
© 2024 MakerWorld