Bit Holder Remix with Relief Cut Corners - Improved Bit Holding
Remixed by
Copyright Claim
Bit Holder Remix with Relief Cut Corners - Improved Bit Holding
Remixed by
Boost
15
24
7
Print Profile(8)
Normal Fit, With Magnet: 0.16mm layer, 3 walls, 15% infill
Designer
18 min
1 plate
Snug Fit, With Magnet: 0.16mm layer, 3 walls, 15% infill
Designer
18 min
1 plate
Normal Fit: 0.16mm layer, 3 walls, 15% infill
Designer
18 min
1 plate
A1 Mini - Snug Fit
Designer
22 min
1 plate
Click to see more
Open in Bambu Studio
Boost
15
24
7
2
77
58
Released
Description
Hate having to use a plyers to remove the bit? Well no longer.
This remix has relief cuts on all the corners meaning the walls are what is holding the bit and not rounded 3D printed corners.
There are 2 versions -
- Just with Relief Cuts
- With Relief Cuts plus cutout to insert a 6mm x 1.5mm magnet in the bottom
Snug Fit = 6.45mm width of Hex for the Bit
Normal Fit = 6.50mm width of the Hex for the Bit.
The Snug (6.45mm) will fit the best if your pressure advance and flow is properly calibrated.
Print this version and the original and i guarantee (or your money back) that this version if far superior.
Comment & Rating (7)
All
Print Profile
Normal Fit, With Magnet: 0.16mm layer, 3 walls, 15% infill
printed great in ABS. Fit my bits perfectly.
0
Reply
Print Profile
Normal Fit, With Magnet: 0.16mm layer, 3 walls, 15% infill
printed great
0
Reply
Print Profile
A1 Mini - Snug Fit
Works well, printed great
0
Reply
Print Profile
Snug Fit, With Magnet: 0.16mm layer, 3 walls, 15% infill
Super funktioniert 👍
0
Reply
Print Profile
Normal Fit: 0.16mm layer, 3 walls, 15% infill
Would be nice if it had a hole to fit the keyring :) but still good
0
Reply
Print Profile
Snug Fit, With Magnet: 0.16mm layer, 3 walls, 15% infill
0
Reply
Print Profile
Normal Fit: 0.16mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld