IKEA Lack table raiser +50mm
Copyright Claim
IKEA Lack table raiser +50mm
Boost
5
15
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
5
15
6
0
23
6
Released
Description
This model allows to raise the lack table by about 50mm so the A1 fits.
Use 3mm woodscrews.
Comment & Rating (6)
All
So I printed this out and it works great but the extruded can’t make it to the top. Is there anything I can do about that?
The designer has replied
0
Reply
Personally I have drilled out a portion of the table, unfortunately I do not use the full height of the printer most of the time so I haven't throught about a solution. I have a slightly taller one (+70mm) listed on my profile however I dont think it will help much .
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great needed to be a tad bit higher for the way I needed it but they work great
The designer has replied
0
Reply
Hi, just made a +70mm one, enjoy
0
Reply
Thank you just what I was looking for
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld