MIAMI DOLPHINS 3D Logo 180mm series by mercadogarzas

mercadogarzas

Hobby & DIY>Sport & Outdoors

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.8 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Miami Dolphins 3d logo 180mm x 180mm

Use with:

“V” connector model

https://makerworld.com/en/models/143573#profileId-156082

Chain from “Billrobland"

https://makerworld.com/en/models/25960#profileId-22348

Need about 30 chain links to fit adult male.

Split key ring

Check out my ACORN link system with Bobbles to make you chain medallion even better

https://makerworld.com/en/models/172187#profileId-189065

models can be shrunken down to 15=14% to make earrings

alternate logos will be made later

Comment & Rating (4)

@3DPrintPioneers

Not going to lie. I was going to print this but looked a little more closely at it thankfully and realized you didn't fully paint the model... Only the top surfaces were painted. Is there some sort of benefit to doing it that way? Also, you have lines that go all the way through the model which causes unnecessary color bleeds and color changes you also forgot to fully color the top fin. I'm just going to make my own model there are too many issues with your design. You might want to make a v2 or something and clean up the model a tad?

(Edited)

The designer has replied

@mercadogarzas

Hi. I dont fully paint the model to make the color snap more when looking it at from an angle. when i started doing these i did fully paint. but i preferred just painting the top layer. it also allows those with only 1 ams to print more than 4 colors. the lines through the whole model are because each color section is its own component. if you had the original stl then you could import the whole design as a set objects in the slicer and paint that way. where do you see color bleeds? i can redo the model and make the layers taller.

@mercadogarzas

i will fix the top fin and repost. thank you for your comments. always looking to do better.

@Abrown2671

Print Profile

0.2mm layer, 2 walls, 15% infill

No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.