Sink Strainer - No Supports
Copyright Claim
Sink Strainer - No Supports
Boost
25
49
23
Print Profile(2)
PETG 0.2mm layer, 6 walls, 25% infill
Designer
1.2 h
1 plate
PLA 0.2mm layer, 6 walls, 25% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
25
49
23
4
126
154
Released
Description
I recommend PETG due to the heat of your faucet, but PLA lasts a few weeks at least. Designed to fit a standard U.S. sink drain. Verify your sink size before printing to ensure it will fit a strainer with a 75.7mm diameter and height of around 17mm. The diameter of your drain can be slightly larger and the height can be slightly taller and this should still work.
Comment & Rating (23)
All
Print Profile
PETG 0.2mm layer, 6 walls, 25% infill
too small for my standard sink. thanks.
0
Reply
Print Profile
PETG 0.2mm layer, 6 walls, 25% infill
It printed ok in Bambu PETG. it did seem to have issues with the sides under portion overhang. I may need to slow down my speeds more.
0
Reply
Print Profile
PETG 0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
PETG 0.2mm layer, 6 walls, 25% infill
Other Issues:nedoléhá to do dřezu i při změně rozměru
0
Reply
Print Profile
PLA 0.2mm layer, 6 walls, 25% infill
I resized it for my basement's utility sink, and it works great! Thanks for the design
0
Reply
Print Profile
PETG 0.2mm layer, 6 walls, 25% infill
Perfect fit, like the handle in center
0
Reply
Print Profile
PETG 0.2mm layer, 6 walls, 25% infill
Printed perfectly with black petg
0
Reply
Print Profile
PETG 0.2mm layer, 6 walls, 25% infill
Nice print, needed to change size for my sink
0
Reply
Print Profile
PLA 0.2mm layer, 6 walls, 25% infill
Resized it for my sink...Works great!
0
Reply
Print Profile
PLA 0.2mm layer, 6 walls, 25% infill
reduced to 50% height to fit to my sink.
Printed in ABS
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld