Search models, users, collections, and posts
Designer Side Table
IP Report
Print Profile(1)
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
Designer
258.5 h
4 plates
Open in Bambu Studio
Boost
86
229
3
0
42
5
Released
Description
My GF found a cute designer side table online. it was over €400,-.
This one is slightly cheaper.
No special settings or supports are needed. Most parts are printed with PETG for its strength and durability. i added a ‘cover’ for the top part of the base which can be printed in any material, so that you have more colours to choose from. The bottom has 4 indents for large furniture protection pads.
You'll need the H2D or similar size printer to make this. The version i printed was 10% larger than this file since it was on a Creality K2 (which is not supported on Makerworld).
I used a combination of superglue and soldering to connect all the pieces, use any form of adhesion at your own risk.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (3)