Search models, users, collections, and posts
Comma3X Offset Mount - Parametric
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
58 min
1 plate
Open in Bambu Studio
Boost
1
1
0
0
5
0
Released
Description
I mounted my comma3 a tad off center, due to this the car hugged the right hand side of the road a lot. To alleviate this, I made a mount to shift the unit further right (for me I needed -30mm). I've iterated on that original unit to make one thats parametric! Load this file into fusion and adjust the 'offset parameter' to whatever you want.
Car is hugging left - Unit should be moved left, offset should be positive
Car is hugging right - Unit should be moved right, offset should be negative
Be sure to print this in PETG/ABS/ASA only as any other filament will melt/deform in the heat.
Category: Vehicles
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)