Palm Tree panels and mounting pegs, compatible with Ikea Skadis pegboard

Included are long and short mounting pegs. Long pegs may be used to offset the printed panel from your Skadis, allowing other attachments to still be used. Short pegs hold the printed panel closer to the Skadis, and may not allow other items to be hung from the panel.

Due to the variability in Skadis holes, and 3d printing in general, you may wish to print a few extra pegs. Sometimes one (side) will be too tight for either the Skadis or the printed panel. I use pliers to push in and remove the pegs when needed. Pegs do not need support when printing, but there is a string or two on the underside, usually, that can just be nipped off.

Sometimes there is funky error when using more than one build plate. So just stick to 01.

Each piece is apx 165mm (at an angle), so should fit on A1 Mini as well. Using the PEI Hot Plate and no glue, pegs stick fine to the plate. But you may want to use a brim on the pegs if using a cold plate or they don't want to stick for you.

This model has ironing top layer on. Adds to print time, but does make the surface smoother.

Enjoy!