Summary

No matter if your house catches fire, or your wife wants you to bring out the garbage at 3am, in emergency cases a flashlight allways comes in handy.
But searching for your flashlight in the dark, can cost you that few seconds, that decide between life and death.
So, be prepared!
With this holder, designed for Maglite, your flashlight is always within reach.

Edit 9.4.2017:
Added a Version with countersunk hole on request for direct mount.

Print Settings

Printer Brand:

RepRap

                                            Printer:                      
fullmetal P3 Steel

Supports:

                                            Resolution:                      
0.2mm

Infill:

30%+

                    
                        Notes:                     This part can be printed in two orientations:

Bottom to the Printplate
or
Back to the Printplate

Although orientation 2 looks amazing while printing, I would recommand the bottom to Printplate orientation, because it needs less retract and should be a little bit stronger, due to layeradhesion.
Printing in this orientation can lead to warping at the front corners if you print without a Brim.