Adapted from the game files, this is the Swee Pal from Palworld in High Resolution, and separated into multiple parts for easier multicolor printing!

Feel free to use the same color for all parts if you prefer to paint afterwards.

You can try to separate the tail from the body and print separately (I added a cube “pin” to allow reassembly afterwards) but this is super fragile at the 25% scale I prefer, so your mileage may vary. Probably only attempt separate printing/assembly at the 40%+ scales.

Print Settings:

The provided .3mf file should have all recommended settings pre-configured, but generally I recommend 0.16mm layer height (lower for single-color).

Tree/organic slim supports

6-7 walls for Purge Into Infill, 4-5 otherwise

Any % infill, higher for heavier model

25% - 50% scale recommended