Micro:bit case
The front and back sides are connected using a piece of 1.75mm filament. I do it by connecting the front and back sides of the empty case, then using a power drill with a 1.8-1.9 mm drill, I clean the tunnel for the filament on both sides.... I connect the halves on one side with filament and then insert the Microbit, close the case and secure it with the second piece of filament. But if you cut it flat, nothing happens, you just push it out with a piece of filament....
Micro:bit case
Slovak language:
Predná a zadná strana sa spája pomocou kúsku vlákna filamentu 1.75mm. Robím to tak, že prázdne puzdro spojím prednú a zadnú stranu následne pomocou akuvŕtačky pomocou vrtáku 1,8-1,9 mm prečistím tunel pre filament na oboch stranách.... Polovice spojím na jednej strane filamentom a potom vložím Microbit púzdro zavriem a zaistím druhým kúskom filamentu.... Kúsok filamentu si nechávam trčať aby som ho ľahšie vybral iba klieštikmi. Ale ak si to zarežete do roviny nič sa nestane proste to kusom filamentu potlačíte von....