Search models, users, collections, and posts
Lampe
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10.9 h
4 plates
Open in Bambu Studio
Boost
81
270
6
2
74
11
Released
Description
Content has been automatically translated.
Greetings :)
Allow me to present a lamp of my own creation :) featuring an interchangeable shade
For its construction, I utilized standard PLA; however, for the lampshades, translucent PLA was specifically employed
Notably, the shade itself was printed without any infill
Optionally, an additional inlay may be printed to further augment the ambiance
The lighting mechanism is structurally identical to that offered by Bambu Lab itself
The magnets incorporated herein measure 10x3mm
Should there be any opportunities for refinement or enhancement, I kindly request you to reach out to me
I am profoundly appreciative of any constructive suggestions for improvement!
Warmest regards ;)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)