Cable germination
Cable germination
Boost
23
27
4
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Boost
23
27
4
0
62
7
Released
Description
My desk is always full of cables from various devices, so I wanted to make them a little more interesting!
It is recommended to use cold plate printing.
Comment & Rating (4)
All
Sweet idea - it was just pretty hard to get the small little cable clips together. A bit more flexible Material like PETG or TPU might make it much easier. But I also printed on the hot plate because i don't have the cool one yet. That might make a difference too.
(Edited)The designer has replied
1
Reply
Thank you for your suggestion!
I did base this model off of a single cable.
This is a great idea!
I think it would be better to just make another version that can accommodate multiple cables. Although there is no way to upgrade this model immediately, I have put it in my plan!
Thanks!
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Mega cute!
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Looks cute. The closings mechanism is a bit fiddly, but after 1-2 you get the hang of it. Holders for different cable sizes would be nice though.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld