In order to see the differences in a filament when you print it with different layer heights AND to remember afterwards which print is which and not use too much filament, I have created templates of my calibration cube and saved a profile for each layer height.

If I need to decide quickly between two settings, I print both of them and can make a good decision based on a physical sample.

I can also use it to evaluate the printing behavior in general.

New Version with rounded surface

https://makerworld.com/en/models/206909#profileId-227010

-------------------------
❤️ Thanks for ur support ❤️

usually make the designs for myself, I am also happy to make them available... Work doesn't have to be done twice. 🤷♂️

If you like the files and would like to support me a little, I would be thankful 🖖🤓

https://www.buymeacoffee.com/soerenharaldsson