chinese folding fans by N3komata

N3komata

Fashion>Other Fashion Models

This model is created by Make My Sign

Make Your Model

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

3.6 h

2 plates

3.0(1)

Open in Bambu Studio

Boost

Released

Description

if you whant diy you‘r own fan，use brand creater and cut it with mold

chreey

Comment & Rating (6)

@awayheflies

Print Profile

0.2mm layer, 2 walls, 15% infill

The peg is not long enough to put enough segments for it to fan out into a semi-circle, plus there are no assembly instructions (that I could see). I printed the fan segments plate twice, and the peg is long enough to fit all but 3 of the segments and still get the other end on. Then this only fans out to a maybe 110° angle. It would look better with the remaining 3 segments but still not a full 180°. I also think the pattern could have been embedded rather than just sat on top. Pretty though.

@awayheflies

Here’s what I ended up doing: I sliced the peg off of the end segment model and elongated it to 3.6cm, printed this and another end segment with the hole in it, then I put the peg through all the segments and the two ends (both with holes), and melted the ends of the peg so they mushroom over the end segments. Then I sewed it using the instructions from a voronoi hand fan also available in this bambu labs database. It turned out okay

(Edited)