Mossanda Lux | PalWorld | Desk Toy | Figure | Display | Panda by Keebitzenny

Keebitzenny

Art>Sculptures

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

4.1 h

1 plate

4.0(2)

Open in Bambu Studio

Boost

Released

Description

After making Relaxaurus Lux, I had to follow up with this guy! Unfortunately, this guy does require some supports due to his shape, but I did split it into as many parts as possible to printing and assembly easier.

Comment & Rating (8)

@KillaPrintzilla

Print Profile

0.2mm layer, 2 walls, 15% infill

(Edited)

Bed Adhesion Issue:not enough attention to detail, clearly not tested. As this has little chance to succeed, and high chance of causing larger issues then a failed print. spiked hair part has a z layer shift, and is missing partial area for layer one and final layer opposite area part. lucky I was around to stop it before it got bad. sorry if I was too harsh. I get it's easy to forget a minor detail or even not notice an issue from who knows where to be fair everything else printed well. thanks for the replies.

The designer has replied

@Keebitzenny

I’m sorry you had bed adhesion issues with this print. This head piece is the same orientation as well as fitment as my relaxaurus model, which have been test fitted prior to posting.

@KillaPrintzilla

check the first layer on slicing plate. there is a floating 2nd layer due to this gap in the first layer. there is a similar effect on top layers aswell. unless there is a picture of your successful print I'm not sure I believe you made this print well.

(Edited)

@Keebitzenny

Replying to @KillaPrintzilla :

I see exactly what you mean! My apologizes you’re very right. When I made mine, I had literally used the fin from my relaxaurus lux since I had a couple of them handy; them being the same exact piece as stated before. Thank you for the correction and remix as I have seen you post.