UPDATE: I added 2 new files based on comments from users. Fixed Thin Wall Handle has some additional geometry added to the bottom of the handle. It was very thin plastic at the screw portion of the handle and a user had some failures printing. This should fix that. I also added a longer handle. Its double the size so if you want to fit more dice in your weapon then thats the one for you. 

Here is a buster sword dice box. It has 2 compartments. Everything prints support free. 6 8x2mm magnets are needed to combine the snap piece and the main piece together. The handle and end of the handle a screw together. Comment below if I should make a dice tower out of this where the tip of the sword is in the rocks and you roll the dice down the handle.

https://www.youtube.com/shorts/-tXtH-xUXnc