Flipper Zero WiFi module case by THE AYPISAM FPV

THE AYPISAM FPV

Hobby & DIY>Electronics

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

Full case with minimalist design

Designer

1.3 h

1 plate

4.6(5)

Full case, top with buttons

Designer

44 min

1 plate

3.8(9)

Open in Bambu Studio

Boost

131

Released

Description

A fully 3D printable case for the Flipper Zero Wi-Fi module.

Recommended settings:

top with buttons → use liquid glue for better adhesion
0.1 X-Y (horizontal) hole compensation (0.2 for -CF filaments)
0.2 Layer Height (if LED holes is too opaque, use 0.1 for the first layer)
Auto orient all 3 files for better results

Comment & Rating (23)

@dsf1970

Print Profile

Full case, top with buttons

looks good one side the pins fit fine the other side they are 2 big for the hiles

The designer has replied

@THEAYPISAMFPV

thanks for the feedback! depending on the type of filament, the holes for the pins might be too small. same for the single layer (.2mm) for the led, for -cf and matte filament I found that it works better with a .1mm height on the model, and first layer at .15mm.

@dsf1970

Replying to @THEAYPISAMFPV :

I printed it again no luck .15 first layer , .1 for the rest. It's weird because the original pin protector at .2mm fit perfectly and the push buttons are move freely. I'm trying to learn Fusion 360 I may try to look at the model in there and check the sizes.

(Edited)

@THEAYPISAMFPV

Replying to @dsf1970 :

yeah the LED hole is tricky as it depends on your filament if the led light will be visible or not

@Djomaster

Print Profile

Full case, top with buttons

perfect

@Printynator

Print Profile

Full case, top with buttons

the hole for the led light is closed, thats not But it's so bad that the housing is very difficult to put together and the pins do break

The designer has replied

@THEAYPISAMFPV

The led light hole is tricky, if your filament is too opaque it will never work. if The housing is difficult to print, open in it bambu studio and increase the "X - Y hole compensation", as it will depends on your filament.

(Edited)

@Sarges3DDesigns

agree, the design could definitely improve in those areas.

(Edited)

@TEACCHDoGG

Print Profile

Full case, top with buttons

didn’t fit. connection is to covert too much.

The designer has replied

@THEAYPISAMFPV

it all depends on your filament, if you've set your flow rate correctly. please provide images of what's wrong

@Sarges3DDesigns

Design needs improvements as stated in other comments. Board figment in front & back housing is great however, the housing pins need to be adjusted. while inside led hole is great, it’s covered on the outside. Buttons could also use some adjustments. A great start to the design and some minor tweaks would get it a 5 star review.