IKEA SKADIS Homepod mini holder
Copyright Claim
IKEA SKADIS Homepod mini holder
Boost
73
180
30
Print Profile(2)
0.2mm layer, 3 walls, 20% infill
Designer
1 h
1 plate
0.2mm layer, 3 walls, 20% infill
1.4 h
1 plate
Boost
73
180
30
6
231
152
Released
Comment & Rating (30)
All
Boosted
like it, easy to print.
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
perfekt 👌
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
printed straight from the Bambu handy app. works perfectly!
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
very nice print. thank you
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Great model except the wire routing. Not sure if it's a new revision, but the USB type C cable does not fit through Skådis holes. I tried widening a little bit but no luck. Also a bit strange to reverse the volume buttons but I understand why.
Sorry about the rating- I tried to give 4 stars but the print had to be restarted due to a bed issue and it did not record a successful print...
(Edited)
1
Reply
can u make it compatible with the a1 mini
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Tree supports can be awkward in the small hole if no pliers on hand
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
es el segundo que imprimo, va muy bien
0
Reply
model itself is fine, my cord doesn’t fit through the skadis slot though. must be a different version. but the model is fine :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Perfect!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld