Adjustable Foldable Phone and Tablet Stand by Tekk3D

Tekk3D

Household>Office

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Small Complete

Designer

2.2 h

1 plate

4.2(11)

Tablet Complete

Designer

4.8 h

1 plate

3.7(3)

Open in Bambu Studio

Boost

172

367

208

Released

Description

one Print Profile for Tablets and one for Phones!

You can adjust the cell phone holder in both swivel joints using the 2 rotary controls.

There are small snap-in points in all components to prevent it from slipping in the direction of rotation

you can also fold it up to save space!

Comment & Rating (20)

@MagicJJ

Print Profile

Small Complete

one of the supports is basically super glued onto the item. all other support and items removed very easily.

@AstraCD

Stuck support doesn't have anything to do with model design. It has to do with the filament and also flow of the filament. Not my design but I just don't like to see people giving lower ratings to designers for something that is not designer fault.

(Edited)

@MagicJJ

Replying to @AstraCD :

so a 4 is low? I could have went 3 if I chose... Bambu needs to remove the numbering from their ratings and go with a lettering system. the remixed design for this on Printables didn't have this issue. much love 🫶🏾

@zrowfks

I had the exact same build up in the exact same spot. I filed it down and applied some heat to give it back a shiny look.

@Roobarbify

Boosted

Print Profile

Small Complete

printed really well!!

@for35t

Boosted

Print Profile

Small Complete

Printed with army green.

@sgenos

Print Profile

Small Complete

Nice support, but be careful the small model is really small

@simonjen26

Print Profile

Small Complete

Beim ersten Mal ist es schief gelaufen

@nkornbau

Print Profile

Small Complete

Original: Could not get this model to print well. Supports were very difficult to remove, sometimes cracking the actual part. Tried multiple prints of the screws, but they always came loose during print, even with a freshly cleaned textured pei plate. Tried different materials all with settings that work well for other prints. Update: Printed with PETG instead of PLA+. Screws stayed in place during print and supports were easier to remove! Still not sure what is wrong with my PLA+ settings.

(Edited)

The designer has replied

@Tekk3D

maybe youre print settings are just bad. check your settings and get your printer to work before making a bad comment. my prints were always fine and i even print with abs.

@nkornbau

Replying to @Tekk3D :

I'm glad your prints turn out well! I really tried to get this to work on my printer, I love the design. I tried a few different PLA filaments all with settings that have produced dozens of good prints in the past. Any suggestions on what settings I should adjust?

@3good

Boosted

Print Profile

Tablet Complete

I had to reprint the bolts because they fell during the initial print. Printing the bolts alone had no issues. I think this model may be slightly too large to print as is on an A1 mini. Printing bolts on a second plate worked wonders.

@foxlassl16

Print Profile

Small Complete

Strength Issue

@user_2071361717

Print Profile

Tablet Complete

One of the pieces had a weak joint And snapped as I tried to assemble

Strength Issue

@emanuele_24_12

Print Profile

Tablet Complete

works very good, supports could be tuned better in the profile, i had a pretty rough surface that normally is better if i slice myself. all in all it's good though