Sits very tightly and is a bit higher than my other keycaps, but the print is good! I flipped it on the plate and printed with support, so that I could iron the topmost layer. Removing supports was a nightmare, but the result looks great!

Nice snug fit, printed perfectly with Bambu Labs PLA CF filament. Fits on WS Silent Grey switch and standard cherry stem switches

Replaced broken "W" key

nice

Great design, I use a lot in my keyboards

Lovely design, I modified the size a bit to match my keycaps. Thanks for sharing!

I modified the project to print less prime lines. Tried to add a negative text but it is almost unnoticable. And set the bottom patter to hilbert curve which was a mistake. The keycap print is not perfect, but 100% functional.

Fast print without any problems.

Very nice design, but sadly didn't fit for my keyboard.

very good!