Suspended Hand


Print Profile(8)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
P1S, P1P, X1, X1 Carbon, X1E, A14 h
4.8
0.2mm/2 walls, 10-20% rectilinear, 80g, 2h46m
0.2mm/2 walls, 10-20% rectilinear, 80g, 2h46m
X1 Carbon, P1S, P1P, X1, X1E, A12.8 h
4.8
0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
A1 mini, P1S, P1P, X1, X1 Carbon, X1E, A14.6 h
4.9
0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
X1 Carbon, P1S, P1P, X1, X1E, A110.7 h
4.8
Click to see more

1191
1553
801
5.7 k
3.5 k
Released
Copyright Claim
Model
Comment & Rating
Remixes
Related Models

Description

I created this suspended hand artwork using bridges for the strings. You don't need any supports.

It prints in 0.2mm layer height and wall generator set to Arachne in Bambu Studio.

The easiest way to print in multicolor is to use the full model and apply the color you want for the strings on the entire model and then apply the other colors to the structure and the hand.


License

Comment & Rating (801)

Please fill in your opinion
0/5000

Print Profile
0.2mm layer, 2 walls, 15% infill
I used glow in the dark filament and it turned out pretty amazing. looks especially great in the dark.
5
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in copper silk PLA. Results were perfect!
5
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Well, I had major issues removing the print from the build plate, but I think that is on me. The model is really nice.
2
Reply
No nono This looks great too
(Edited)
4
Reply
Replying to @liuye :
agreed
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
super cool print and it turned out absolutely amazing! only had one feed/retract error and that was due to a nearly empty roll. the two tone really makes it pop!
3
Reply
Matte Gray
3
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
love this model
GIF
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it came out very clean! great job
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This turned out amazing. The exterior is firm and stiff with no concerns of if it being to brittle or weak. It's so cool! Great job.
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A few issues, but I believe the problem was with mainly with my filament.
The designer has replied
1
Reply
If you use another filaments that eSUN change profile to Generic PLA or self tune profile :>
0
Reply