Bathroom Shower Shelf | Spiral

🛠️ Installation Guide:

1.      Avoid touching the mounting area on the model where the tape will be applied to ensure the best adhesion (like a pressure plate, touching reduces grip)

    

2.  Clean and dry both the mounting spots on the model and the wall area where the shelf will be fixed. Use isopropanol or similar cleaner for best results.

    

3.  Cut the double-sided tape to the required size (recommended size: 7 x 2.5 cm pieces).

    

4.  Apply the tape firmly to the prepared spots on the model. Press down several times for a few seconds to secure good bonding.

    

5.  Remove the outer protective layer from the tape carefully.

    

6.  Attach the shelf carefully to the desired spot on the wall. Press both the shelf and wall sides firmly multiple times for about 5 seconds each to ensure a strong bond.

    

7.  Let it cure without load for at least 24 hours. Ideally, avoid exposing it to water (like showering) for at least 12 hours after installation  to allow the adhesive to set without interference.

    

8.  After 24 hours, if the shelf feels firmly attached even with slight touch, the installation is successful. If it moves, press it firmly again and wait longer, or start over if necessary.

    

9. The adhesive reaches about 90-95% strength after 36-48 hours, after which the shelf can be fully used.

🎨 Design & Dimensions

    •    Triangular shower shelf with 15 cm side length
    •    Flat surface: 1 cm
    •    At the mounting points for adhesive tape: 2.5 cm high
    •    Recommended: double-sided bathroom adhesive tape
    •    A hidden cross brace is optimally placed – providing discreet yet excellent stability.

The spiral design gives the model a modern, lightweight appearance.
 

Maximum Load

    •    For consistent, long-term use, I recommend not exceeding 5 kg.