fantastic cover! I didn't change any settings, I just clicked print. probably by customizing the settings I could improve the quality on the overhangs (internal part). requires a little cleaning after printing but the file is perfect!
Thank you for this. The print came out great and without any issues at all. This is the first time I've ever printed in TPU, using Amazon branded TPU that I bought about 2 years ago and generic settings on the X1C.
Wow thanks a lot for this design! It came out perfectly on my first print. People that complained about the overhangs set their printer wrong.
Set it for a slower speed and a higher fan speed and you'll be good. Should take about 3hr on a ps1.
The only change I would make is maybe slightly thicker walls with slightly rounder fillets.
Also if you want a gripper case, turn on fuzzy edges!
printed with Amazon Basics TPU, and it came out great! as BjornB mentioned there are some floating regions that resulted in some very minor stringing but overall nothing terrible. I'll snap some photos later!
One request would be to have a cutout inside for a magsafe style magnet circle or metal ring to be put in
forgot to mention that the first time I printed it at 100%, it was a bit loose, however scaling it down to 99.25% resulted in a perfect fit with everything aligned well
I tried printing this nearly several times with not much luck. printing with bambu lab tpu, standard settings, changed multiple perimeters, wall count, temprature, layer heights, filliment on the dryer, and I coul not get a successfully print for the life of me.
the over hangs at 90 degrees, weren't playing game for me.