My Minka Aire ceiling fan has this awful spot light that shines directly down on the bed and doesn't defuse the light at all. It's such a terrible design.
So I made a dual color PETG diffuser to help distribute the light better.
Slides over existing light with a top rib to hold on to the edge. Version pictured had tabs which I didn't like so I redid the model.
Added a test ring incase your printer's dimensions come out different. Scale appropriately if yours doesn't match mine. The diameter is 190.20mm on the model.
v2 added 2 extra slits to make it easier to install.
Printer:
Bambu X1C
Rafts:
No
Supports:
Yes
Resolution:
.16
Infill:
15
Filament: Sunlu PETG Grey and White
Notes:
Needs supports to support the center globe. I've used both Tree and Traditional they work about the same. Tree were easier to remove or traditional with a support interface material if you have a multi material system.