Venetian mask 3
Copyright Claim
Venetian mask 3
Boost
200
276
23
Print Profile(3)
0.15mm layer, 3 walls, 15% infill
Designer
4.5 h
1 plate
0.15mm layer, 3 walls, 15% infill
3.7 h
1 plate
venetian mask, 0.15mm layer, 3 walls, 15% infill
3.9 h
1 plate
Boost
200
276
23
5
463
198
Released
Description
Venetian mask 3!, perfect for a masquerade ball :)
The mask does not need support! And the profile is turned off and you have it turned on and you give a negative opinion and that's not my problem ;)
Comment & Rating (23)
All
Print Profile
0.15mm layer, 3 walls, 15% infill
I had to give this 4/5 as my first attempt came off the plate about 45 minutes in. I know it says “no supports needed” and that’s true but this thing needs a Brim layer to help hold it in place. once I added that it was no problem. the small loops are also a PLUS. did not see those in the preview profile so I was surprised
2
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
great print!
(Edited)
0
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
my wife loves it
0
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
Print should probably be slower as it broke one piece of top... But glue fixed it.
0
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
I was flabbergasted when I watched this print flawlessly without supports. Granted, I'm new to FDM printing, but this is a great one to impress your friends.
The designer has replied
1
Reply
Thanks :)
0
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
The small twirly parts did brake on two places and also one leaf
0
Reply
Boosted
Print Profile
0.15mm layer, 3 walls, 15% infill
Beautiful design and prints well in CF PLA. brim can be hard to remove
0
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
i like the design, but few of the tin upper pieces broke during printing. going to try again and adjust settings. because normally that does not happen
0
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
Perfectly printed, daughter loves it.
0
Reply
Print Profile
0.15mm layer, 3 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld