I had to give this 4/5 as my first attempt came off the plate about 45 minutes in. I know it says “no supports needed” and that’s true but this thing needs a Brim layer to help hold it in place. once I added that it was no problem. the small loops are also a PLUS. did not see those in the preview profile so I was surprised
I was flabbergasted when I watched this print flawlessly without supports. Granted, I'm new to FDM printing, but this is a great one to impress your friends.
i like the design, but few of the tin upper pieces broke during printing. going to try again and adjust settings. because normally that does not happen