Bearing based spirographic WDT tool modified
Remixed by
Copyright Claim
Bearing based spirographic WDT tool modified
Remixed by
Boost
66
140
12
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
5.7 h
3 plates
Boost
66
140
12
2
257
187
Released
Description
BOM is the Same as the original, aside from the 8 magnets I used to hold the basket in place when rotating. (Fits my 18g ridgeless VST basket nicely)
I used blind holes on my design to give the upper part a cleaner look.
The use of a blind hole tap is advised to start ¾ of the thread length, otherwise the part may crack when screwing the M3 Screw in an undersized hole.
BOM:
- 16x Magnets 5x2.5mm (2 stacked on top in each hole)
- 1x M3x20mm SHCS
- 5x M3x12 SHCS
- 2x 61813 ZZ / 2Z (65x85x10 mm)
- 10x MR63ZZ (3x6x2.5mm)
- 10x Acupuncture needle
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed most of the parts at one plate and worked great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Excellent print. Bearings and magnets fit perfectly. I was skeptical on if this would make a noticeable difference in my espresso but I was pleasantly surprised. Made a big difference in shot quality. Had some issues with the knob on top - a little fragile in its attachment but this is a great project.
2
Reply
is this a 58 mm?
The designer has replied
1
Reply
yes
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Used a white PETG and results were great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
excellent Modell and print
0
Reply
What's the size of the needle？
0
Reply
How long should the acupuncture needles be?
0
Reply
Looks great. May I ask what filament you have used?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld