Round hygrometer magnetic holder
Copyright Claim
Round hygrometer magnetic holder
Boost
18
34
14
Print Profile(2)
PLA - 0.2mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
PETG - 0.2mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
18
34
14
0
85
70
Released
Description
I wanted my round hygrometer to be close to my plexiglass door, and I didn't want to drill into the door so I made this magnetic hygrometer holder.
It can be placed anywhere you want.
No glue is required.
- 6 * 3 mm magnets.
- Round hygrometer, (41 mm diameter to the base part where the battery is in.
Comment & Rating (14)
All
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
Works very nicely. Magnets have not yet arrived, but the hydrometer/temperature sensor fits very snugly and securely inside. A slight press to get it in - but it wont come out by itself! ;)
The magnets are a perfect fit. I used two 6x3mm Magnets per hole (4 in total) for better grip on any metal surface 👍
(Edited)
The designer has replied
1
Reply
thanks! looking good!
0
Reply
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
Works like a charm! Very clever design to incorporate magnets and I couldn't be happier 😊 Thank you!
The designer has replied
0
Reply
Thank you so much!, 😁
(Edited)0
Reply
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
when I insert the hygrometer through the slot it does not sit straight and it bugs me, other than that the print was great
The designer has replied
0
Reply
What do you mean? can you share a picture?
0
Reply
The magnet holes are through holes. Is there a reason for this, and why they're not made with a "back"?
The designer has replied
0
Reply
Because it was easier to design. The magnets will not come loose if thats what you think =)
0
Reply
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
PETG - 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PLA - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
PETG - 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld