Sonos One wall mount.
Copyright Claim
Sonos One wall mount.
Boost
21
66
19
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
2.4 h
1 plate
Boost
21
66
19
2
127
132
Released
Description
Summary
A Sonos One wall mount I designed for my speaker. Use a 5mm bolt to connect the two together.
It's very important to NOT use countersunk screws in the screw holes, since this would force the layers apart.
More info about this project can be found on http://michaelteeuw.nl
Comment & Rating (19)
All
Print Profile
0.2mm layer, 3 walls, 25% infill
Fit perfectly into my Sonos one! great model, thank you for sharing!
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Prints nicely, but when I tried to use a washer to improve pressure transfer (see picture), I found out there wasn't enough height with this particular screw so I had to remove it.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Perfect! Kable hole to lead it downwards would be even more perfect.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Hat alles super funktioniert danke!
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 25% infill
Very good, didnt know that you can actually adjust it by rotating the platform, which makes it super nice fitting in my corner
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
nice
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Works
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
lacks cable output
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
great
0
Reply
Very very nice - a cable slot in the bracket would be even nicer 😁
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld