Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
46
59
11
4
105
66
Released
Description
Print face down, there are 2x 8mm x 2mm magnet holes on the back.
I put magnets in the holes and place a couple screws in the wall and the magnets hold it up.
Comment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Love it!!
The designer has replied
1
Reply
Thank you so much!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
one small print issue but its not noticeable
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
clean print for my door
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
came out perfect!!!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints well, very nice design.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed good in PLA sparkle.
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld