Apple Watch Stand
Remixed by
Apple Watch Stand
Remixed by
Boost
58
138
86
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
52 min
1 plate
Variable layer height for smoother appearance
1.4 h
1 plate
All printers, 0.2mm layer, 2 walls, 15% infill
1.3 h
1 plate
Boost
58
138
86
0
542
592
Released
Description
Summary
This is a remix of Masto's Apple Watch Dock. I've added a small hole to allow you to remove the charging cable by using a small pin. Ive also made some slight changes to the bottom in order to make more room for the cable.
Enjoy!
Comment & Rating (86)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed well but the clearances for regular usb end was tight but even tighter to fit c type.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Well built, charger fits perfectly. good luck getting it out once it’s in though. Could’ve used a little dip or indention to be able to get it out once it’s in place if it ever needs to be taken with you. Still 5/5 on a scale.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great - except that the cutout in the bottom is not large enough to comfortably get the newest Apple made USB-C cable through it. Maybe this was designed or remixed to fit the older USB-A a cables? I got it through with some cajoling and careful use of needle nose pliers. But a taller opening by two or 3 mm would definitely be appreciated in a future remix.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good stand and fits my watch perfectly.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
turned out great, I used Bambu silk copper
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
super cool!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Einer meiner ersten Drucke mit dem Drucker.
bin mit dem Ergebnis sehr zufrieden. Modell ist gut durchdacht und passt gut.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Der USB A Anschluss ging etwas schwer durch die Öffnung, passte aber mit etwas Nachdruck. Die Oberfläche sieht schön und gleichmäßig aus.
0
Reply
works great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld