Cat Treat Toy
Cat Treat Toy
Boost
240
457
100
Print Profile(5)
Cat Treat Toy - Ladybug Sliders
Designer
2.4 h
1 plate
Cat Treat Toy - Plain Sliders
Designer
2.3 h
1 plate
0.2mm layer, 2 walls, 15% infill
2.8 h
2 plates
0.2mm layer, 3 walls, 15% infill
6.1 h
2 plates
Click to see more
Boost
240
457
100
2
450
562
Released
Description
Your cat must move the sliders to uncover treats. The wells are deep enough to fit most treat sizes or a few pieces of food. Your cat can either eat the treat directly from the well or use their paw to remove it.
Two slider designs are currently available - plain or ladybug. Once 3 sliders are placed on the base, simply place the top in position and gently press down to snap it in place.
Print Settings
Although no special settings are required, a higher infill percentage is helpful to add extra weight to the print. This will make it easier for your cat to move the sliders without the entire toy sliding around. If printing the ladybug sliders, use a color change for the last 0.4mm.
The following filaments were used in the pictures above:
- Prusament Azure Blue PLA
- Polymaker PolyTerra Lava Red PLA
- Polymaker PolyTerra Charcoal PLA
Comment & Rating (100)
All
Print Profile
Cat Treat Toy - Ladybug Sliders
Fun and easy print, went with 2 plates and a filament change at a fixed layer to reduce filament waste.
2
Reply
Print Profile
Cat Treat Toy - Ladybug Sliders
works well my cat couldn’t figure it out though
1
Reply
Really nice toy, made mine in white to match my cat
1
Reply
Print Profile
Cat Treat Toy - Ladybug Sliders
my cat enjoy with that
1
Reply
My cat made it at first time😆
1
Reply
Great print!
1
Reply
Print Profile
Cat Treat Toy - Plain Sliders
My Cat loves it! I taped it on the floor, so it is easier for my sweet boy to get his treats 🐈⬛
1
Reply
Print Profile
Cat Treat Toy - Ladybug Sliders
Print is sweet and after 1 treat, cats are already coming when they hear the ladybugs being moved to add food!
if I printed it once more, I’d possibly print the ladybugs a little thicker (101%?) or from TPU so there is a bit of friction for the cats to work against.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Sweet
0
Reply
Print Profile
Cat Treat Toy - Plain Sliders
My dog likes it too
(Edited)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld