Airtag Keychain
Copyright Claim
Airtag Keychain
Boost
18
41
8
Print Profile(1)
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
18
41
8
0
67
40
Released
Description
The one in the photo is printed with CF PET-G from Prusa.
When printed, just snap in the Airtag and its held snugly.
Best printed with a 10mm brim with the flat top facing the print bed. When placed like this it doesnt require supports.
Support and Feedback:
If you like the design, you can buy me a coffee here: https://www.buymeacoffee.com/kazikg
Encountered any issues or have suggestions? Feel free to leave a comment below. I'm here to assist and continuously improve this design. Your feedback is invaluable! :)
Comment & Rating (8)
All
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Printed perfectly and works great!!!
(Edited)
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Title say it all, I really like it, it’s super fast and practical, just want to notice the AirTag is super hard to make it slip from the case, personally print it with Matte PLA, and even if it fall, IT’s and AirTag can’t loose it xD. Thanks for the profile :)
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
was very tight for my AirTag. it was difficult to get it out again
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
perfetto per PLA-CF
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
printed well but didn’t quite hold on to the AirTag as expected. I wound up going with a different design for a keychain AirTag holder
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld