Star Wars The Mandalorian Blaster (4 pieces, fast print, with connectors, no ugly supports) by GamerForge

GamerForge

Props & Cosplays>Replica Weapon

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 10% infill

Designer

5.9 h

2 plates

4.5(27)

0.2mm layer, 3 walls, 10% infill

8.3 h

2 plates

5.0(1)

Open in Bambu Studio

Boost

175

329

345

296

Released

Description

I'm making a "The Mandalorian" blaster in 4 parts.

for better printing, faster Printing !!, with connectors, without ugly supports and no unnecessary assembly, simply simple and good!!

happy printing :)

Comment & Rating (39)

@PeterHall

Print Profile

0.2mm layer, 3 walls, 10% infill

Very good profile, far more thought through than I would have managed! :)

The designer has replied

@GamerForge

looks awesome !! thanks for rating and the other profil <3

(Edited)

@Infinity3DPrint

what’s the little nub on the bottom ? is it extra ? and what’s the other part is something supposed to slide into it?

@PeterHall

Replying to @Infinity3DPrint :

Good question, I wonder that also. I have seen the cutout is on other models too, believe this is a simplified remix (it's not my model, I only printed it). Maybe for a stand?

(Edited)

@PeterHall

Very nice model. Found it a bit hard to fit between the left and right side however, there were connectors between upper and lower parts, but not between left and right. Either way, thanks for this, much appreciated!

(Edited)