I printed it with your profile and everything but the finish on top ain't that good. Somehow you can see the infill through the top although the top shell layers are set to 5. I would increase it to 10 and it should be no issue at all. Other than that, thank you for the model.

Very nice model – 5 Stars. The print was flawless but for the wall between the in the "I". If printing again, I would edit the model to either open in another layer or open the base layer in some regions to have better access. Even the 6.5mm wide LED strip I used was a lesson in patience. :-)

came out great the “P” was a little tight and took some coaxing but otherwise flawless! p.s. the dot above the I doesn’t have a tunnel?

what kind of LED is everyone using on this one?

It was a little tough getting the lights in, but it looks great all lit up!

I am hoping this works with Gyroid..... i had it preset and it has printed the entire first plate in gyroid instead of grid