LED Lamp
Copyright Claim
LED Lamp
Boost
41
72
8
Print Profile(3)
0.16mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
0.16mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
0.16mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
41
72
8
4
72
15
Released
Description
A minimal lamp for your room.
You need:
90cm led strip
switch 9x13mm internal diameter
12v connector
some cable
you have to print all the pieces and follow the assembly in this order:
1. pass a cable through the two holes in the cylinder and fix the 12v connector with a bit of glue
2. position the donut, to make it pass you will have to push the cable in and then pull it out again
3.solder the LED strip with the cable just passed
4.now roll up the strip adding a drop of glue every now and then
5.now solder the swith and put the cover on your lamp
6.this is the final result
If you want to support me: Thanks
Comment & Rating (8)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
I CANNOT EXPRESS HOW GOOD THIS PRINT IS! Nothing really bad at all, printed on my p1s without supports for the holes. One small thing would be that the difuser diddnt connect to the main body without superglue as it was a little loose. I dont know if that was on puropse though but again great model
The designer has replied
1
Reply
Thank you, I'm very happy that you liked my project
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld